Pass Fortinet NSE7_SDW-6.4 Exam with Guarantee Updated 82 Questions
Latest NSE7_SDW-6.4 Pass Guaranteed Exam Dumps Certification Sample Questions
To be successful in this certification exam, candidates need to have a strong understanding of how to design and deploy secure SD-WAN solutions that meet customer requirements while adhering to industry best practices. This requires an in-depth knowledge of Fortinet's SD-WAN products, Security Fabric integration, advanced routing techniques, and network technology standards. With the Fortinet NSE7_SDW-6.4 certification, networking professionals can demonstrate their ability to deliver successful SD-WAN solutions that provide higher network availability, better application performance, and stronger network security.
NEW QUESTION # 41
Refer to the exhibit.
Based on output shown in the exhibit, which two commands can be used by SD-WAN rules? (Choose two.)
- A. set source 100.64.1.1.
- B. set priority 10.
- C. set load-balance-mode source-ip-based.
- D. set cost 15.
Answer: B,C
NEW QUESTION # 42
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )
- A. It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links
- B. It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance
- C. It provides direct connectivity between all sites by creating on-demand tunnels between spokes.
- D. It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub
Answer: A,D
NEW QUESTION # 43
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. A single user uses the allocated bandwidth divided by total number of users.
- B. The 10 Mbps bandwidth is shared equally among the IP addresses.
- C. Each IP is guaranteed a minimum 10 Mbps of bandwidth
- D. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
Answer: D
Explanation:
Reference:
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/885253/per-ip-traffic-shaper
NEW QUESTION # 44
Refer to the exhibit.
Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)
- A. The traffic shaper drops packets if the bandwidth exceeds 6250 KBps.
- B. The traffic shaper drops packets if the bandwidth is less than 2500 KBps.
- C. The measured bandwidth is less than 100 KBps.
- D. The traffic shaper limits the bandwidth of each source IP to a maximum of 6250 KBps.
Answer: A,C
NEW QUESTION # 45
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Interface-based shaping mode
- B. Reverse policy shaping mode
- C. Per-IP shaping mode
- D. Shared policy shaping mode
Answer: A
Explanation:
SD-WAN 6.4.5 Study Guide. pg 124
NEW QUESTION # 46
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. Dead members require manual administrator access to bring them back alive
- B. Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
- C. SD-WAN interface becomes disabled and port1 becomes the WAN interface
- D. Port2 might become alive when a single response is received from an SLA server
Answer: B
NEW QUESTION # 47
What are two reasons for using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It acts as a policy compliance entity to review all managed FortiGate devices.
- B. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- C. It improves SD-WAN performance on the managed FortiGate devices.
- D. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- E. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
Answer: B,D
NEW QUESTION # 48
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
- B. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- C. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
- D. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
Answer: C,D
NEW QUESTION # 49
Refer to the exhibit.
Based on the exhibit, which two actions does FortiGate perform on traffic passing through the SD-WAN member port2? (Choose two.)
- A. FortiGate always blocks all traffic after a route change.
- B. FortiGate performs routing lookups for new sessions only after a route change.
- C. FortiGate marks the routing information on existing sessions as persistent.
- D. FortiGate flushes all routing information from the session table after a route change.
Answer: B,C
NEW QUESTION # 50
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. ADVPN should only be enabled on unmanaged FortiGate devices.
- B. The protected subnets should be set to address object to all (0.0.0.0/0).
- C. Each VPN device has a unique pre-shared key configured separately on phase one.
- D. On the hub VPN, only the device needs additional phase one settings.
Answer: C
Explanation:
Explanation/Reference:
NEW QUESTION # 51
An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links One link has random jitter and latency issues and is based on a wireless connection Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD_WAN rules?
- A. Select the corresponding SD-WAN balancing strategy in the SD-WAN rule
- B. Choose the suitable interface based on the interface cost and weight
- C. Place the troublesome link at the top of the interface preference list.
- D. Configure an SD-WAN rule to load balance all traffic without VoIP
- E. Use the performance SLA targets to detect latency and jitter instantly.
Answer: B,E
NEW QUESTION # 52
Refer to the exhibit.
Multiple IPsec VPNs are formed between two hub-and-spokes groups, and site-to-site between Hub 1 and Hub 2 The administrator configured ADVPN on the dual regions topology
Which two statements are correct if a user in Toronto sends traffic to London? (Choose two )
- A. London generates an IKE information message that contains the Toronto public IP address
- B. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
- C. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN
- D. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
Answer: B,C
NEW QUESTION # 53
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager
- B. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- C. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices
- D. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager
Answer: A,B
NEW QUESTION # 54
When attempting to establish an IPsec tunnel to FortiGate, all remote users match the FIRST_VPN IPsec VPN. This includes remote users that want to connect to the SECOND_VPN IPsec VPN. Which two configuration changes must you make on both IPsec VPNs so that remote users can connect to their intended IPsec VPN? (Choose two.)
- A. Configure different proposals.
- B. Change the IKE mode to aggressive.
- C. Configure a unique peer ID.
- D. Configure different Diffie Hellman groups.
Answer: B,C
Explanation:
https://kb.fortinet.com/kb/documentLink.do?externalID=10114
NEW QUESTION # 55
Which statement about using BGP routes in SD-WAN is true?
- A. Adding static routes must be enabled on all ADVPN interfaces.
- B. Dynamic routing protocols can be used only with non-encrypted traffic
- C. VPN topologies must be form using only BGP dynamic routing with SD-WAN
- D. Learned routes can be used as dynamic destinations in SD-WAN rules
Answer: C
NEW QUESTION # 56
Which CLI command do you use to perform real-time troubleshooting for ADVPN on either a hub or a spoke FortiGate?
- A. diagnose sys virtual-wan-link service
- B. get router info routing-table
- C. diagnose debug application ike
- D. get ipsec tunnel list
Answer: C
NEW QUESTION # 57
Refer to the exhibit.
Which conclusion about the packet debug flow output is correct?
- A. The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
- B. The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped.
- C. The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.
- D. The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped.
Answer: C
NEW QUESTION # 58
Refer to exhibits.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?
- A. Port1 became dead 1ecause no traffic was offload through the egress of port1.
- B. Both SD-WAN member interfaces have used separate SLA targets.
- C. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
- D. SD-WAN member interfaces are affected by the SLA state of the inactive interface
Answer: C
NEW QUESTION # 59
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)
- A. It acts as a policy compliance entity to review all managed FortiGate devices.
- B. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- C. It improves SD-WAN performance on the managed FortiGate devices.
- D. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- E. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
Answer: A,B
NEW QUESTION # 60
Refer to exhibits.
Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?
- A. The guaranteed-10mbps option must be selected as the reverse shaper option.
- B. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
- C. The guaranteed-10mbps option must be selected as the per-IP shaper option
- D. The reverse shaper option must be enabled and a traffic shaper must be selected
Answer: D
NEW QUESTION # 61
Which statement is correct about the SD-WAN and ADVPN?
- A. ADVPN interface can be a member of SD-WAN interface.
- B. Dynamic VPN is not supported as an SD-Wan interface.
- C. Spoke support dynamic VPN as a static interface.
- D. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
Answer: B
NEW QUESTION # 62
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?
- A. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.
- B. The dead member interface stays unavailable until an administrator manually brings the interface back.
- C. Port2 needs to wait 500 milliseconds to change the status from alive to dead.
- D. Check interval is the time to wait before a packet sent by a member interface considered as lost.
Answer: A
NEW QUESTION # 63
......
New NSE7_SDW-6.4 Test Materials & Valid NSE7_SDW-6.4 Test Engine: https://www.pass4sures.top/NSE-7-Network-Security-Architect/NSE7_SDW-6.4-testking-braindumps.html