Guaranteed High Marks with Updated & Real 350-801 Dumps pdf Free Updates
PASS RATE CCNP Collaboration 350-801 Certified Exam DUMP
NEW QUESTION # 17 
Refer to the exhibit. A call is failing to establish between two SIP Devices The called device answers with this SOP. Which SDP parameter causes this issue?
- A. The RTP port is set to 0.
- B. The media stream is set to sendonly.
- C. The payload for G.711ulaw must be 18.
- D. The calling device did not offer a ptime value.
Answer: A
NEW QUESTION # 18
Refer to the exhibit.
Refer to the exhibit. A user takes a phone from San Francisco to New York for a short reassignment. The phone was set up to use the San Francisco device pool, and device mobility is enabled on the Cisco UCM. The user makes a call that matches a route pattern in a route list that contains the Standard Local Route Group. To where does the call retreat?
- A. The call egresses in San Francisco because the user uses device mobility and is allowed to roam while still keeping the number and resources assigned in San Francisco.
- B. The call fails because device mobility is turned on, and the phone is not configured in New York. The engineer must configure which sites the device should be roaming to.
- C. The call fails because the Standard Local Route Group is being used only it no configuration is set for the device pools.
- D. The call egresses in New York because the device automatically is assigned a New York device pool and uses the local gateway.
Answer: A
NEW QUESTION # 19
Due to service provider restriction, Cisco Unified Communications Manager cannot send video in the SDP. Which two options on Cisco Unified CM are configured to suppress video in the SDP is outgoing invites? (Choose two.)
- A. Check the Send send-receive SDP in mid-call INVITE check box on the SIP trunk SIP profile.
- B. Add the audio forced command to voice service voip on the Unified Border Elements.
- C. Set Video bandwidth in the Region settings to 0.
- D. Check the Retry Call as Audio on the SIP trunk
- E. Change the Video Capabilities dropdown on the endpoint to Disabled.
Answer: C,D
Explanation:
The reason is it has to be only in CUCM per the question. You would create a specific Region relationship for the Device Pool applied to the trunk that cannot handle video and thus change the Maximum Video Bandwidth to 0 while setting retry a video call as audio on the Phone Configuration (default setting is this is already checked).
NEW QUESTION # 20 

Refer to the exhibit. Endpoint A calls endpoint B. What is the only audio codec that is used for the call?
- A. Telephone-event/8000
- B. G7221/16000
- C. G722/8000
- D. PCMA/8000
Answer: B
NEW QUESTION # 21
An engineer troubleshoots a Cisco Jabber login problem on a Windows PC in the corporate network. The login fails with the error message "Cannot find your services automatically. Click advanced settings to set up manually.'' Which action should the engineer take first?
- A. Perform a manual DNS lookup of SRV record _collab-edge._tls.domain.com.
- B. Verify whether the cup-xmpp certificates are valid.
- C. Verify the username and password and try again
- D. Perform a manual DNS lookup of SRV record _cisco-uds.tcp.domain.com.
Answer: D
NEW QUESTION # 22
Which two types of device are supported by the Bulk Administration Tool? (Choose two.)
- A. H.225 trunks
- B. H.323 clients
- C. Cisco Unified IP phones (all models)
- D. SIP trunks
- E. Music on hold servers
Answer: B,C
NEW QUESTION # 23
An end used at a remote site is trying initiate an ad hoc conference call to an end user at the main site the conference bridge is configured to support G.711 remote user phone only support G.729 the remote end user receives an error message on the phone "cannot complete conference call what is the cause of the issue?
- A. The remote phone does not have the conference feature assigned.
- B. A Media Termination Point is missing
- C. The transcoder resource is missing.
- D. A software conference bridge is not assigned
Answer: C
NEW QUESTION # 24
An engineer must extend the corporate phone system to mobile users connecting through the internet with their own devices. One requirement is to keep that as simple as possible for end users. Which infrastructure element achieves these goals?
- A. Cisco Express Mobility
- B. Cisco Unified Border Element
- C. Cisco Unified Instant Messaging and Presence
- D. Cisco Expressway-C and Expressway-E
Answer: B
NEW QUESTION # 25
Refer to the exhibit.
The translation rule is configured on the voice gateway to translate DNIS. What is the outcome if the gateway receives 0255-343-1234 as DNIS?
- A. The translation rule is not matched because DNIS does not end with a "$".
- B. The translation rule is matched and the translated number is 025553431234.
- C. The translation rule is matched and the translated number is 02553431234.
- D. The translation rule is not matched because DNIS contains "-".
Answer: C
NEW QUESTION # 26
A company wants to provide remote users with access to its on-premises Cisco collaboration features.
Which components are required to enable Cisco Mobile and Remote Access for the users?
- A. Cisco Expressway-E, Cisco Expressway-C, and Cisco UCM
- B. Cisco Expressway-E, Cisco IM and Presence Server, and Cisco Video Communication Server
- C. Cisco Unified Border Element, Cisco UCM, and Cisco Video Communication Server
- D. Cisco Unified Border Element, Cisco IM and Presence Server, and Cisco Video Communication Server
Answer: A
Explanation:
https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Collaboration/enterprise/12x/120/collbcvd/e dge.html
NEW QUESTION # 27
Refer to the exhibit.
An engineer is troubleshooting a codec negotiation issue where both endpoints that are involved in the call support the codecs listed in the exhibit. Which audio codec is selected il a call between two endpoints in Region 1 is placed?
- A. G.722
- B. G.729
- C. G.711u
- D. G.711a
Answer: A
NEW QUESTION # 28
An engineer roust deploy the Cisco Wet*x app to a Windows Virtual Desktop Infrastructure environment that has a roaming database named spark roaming_store stored In a user's AppData\Roaming directory, Which two command line arguments must be used when running the installer? (Choose two.)
- A. ALLUSERS=1
- B. ALLUSERS=0
- C. ROAMINGENABLED=1
- D. ENABLEVDI=2
- E. ENABLEVDI=1
Answer: C,E
Explanation:
The Cisco Webex app can be installed on a Windows Virtual Desktop Infrastructure (VDI) environment by using the following command-line arguments:
ENABLEVDI=1 - This argument enables VDI mode for the Webex app.
ROAMINGENABLED=1 - This argument enables roaming for the Webex app.
The ALLUSERS argument is not required when installing the Webex app on a VDI environment. The ENABLEVDI argument must be set to 1, and the ROAMINGENABLED argument must be set to 1.
The following is an example of the command that can be used to install the Webex app on a VDI environment:
Code snippet
msiexec /i WebexApp.msi ENABLEVDI=1 ROAMINGENABLED=1
NEW QUESTION # 29
Which description of the function of call handlers in Cisco Unity Connection is true?
- A. They collect information from callers by playing a series of questions and recording the answers.
- B. They provide access to a corporate directory by playing an audio list that users and outside callers use to reach users and leave messages.
- C. They control outgoing calls by allowing you to specify the numbers that Cisco Unity Connection can dial to transfer calls, notify users of messages, and deliver faxes.
- D. They answer calls, take messages, and provide menus of options.
Answer: D
Explanation:
Section: Collaboration Applications
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/connection/10x/administration/ guide/10xcucsagx/10xcucsag080.html
NEW QUESTION # 30
Which version is used to provide encryption for SNMP management traffic in collaboration deployments?
- A. SNMPv3
- B. SNMPv2
- C. SNMPv1
- D. SNMPv2c
Answer: A
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/snmp/configuration/xe-16/snmp-xe-16- book/nm-snmp-encrypt-snmp-support.html
NEW QUESTION # 31 
Refer to the exhibit. Which route pattern can the Cisco UCM administrator apply to the configuration to allow calls to "1306.1316.1326,13*6.13#6" only?
- A. 13[A3-9)6
- B. 13!#
- C. 13[25-8]6
- D. 13XX
Answer: A
NEW QUESTION # 32
Refer to the exhibit. A user takes a phone from San Francisco to New York for a short reassignment. The phone was set up to use the San Francisco device pool, and device mobility is enabled on the Cisco UCM. The user makes a call that matches a route pattern in a route list that contains the Standard Local Route Group. To where does the call retreat?
- A. The call egresses in New York because the device automatically is assigned a New York device pool and uses the local gateway
- B. The call fails because the Standard Local Route Group is being used only if no configuration is set for the device pools
- C. The call egresses in San Francisco because the user uses device mobility and is allowed to roam while still keeping the number and resources assigned in San Francisco
- D. The call fails because device mobility is turned on. and the phone is not configured in New York The engineer must configure which sites the device should be roaming to
Answer: A
NEW QUESTION # 33
Which external DNS SRV record must be present for Mobile and Remote Access?
- A. _cisco-uds._tls example.com
- B. _cisco-uds._tcp.example.com
- C. _collab-edge._tcp.example.com
- D. _collab-edge._tls.example.com
Answer: D
NEW QUESTION # 34
Which behavior occurs when Cisco UCM has a Call Manager group that consists of two subscribers?
- A. Endpoints attempt to register with (he bottom subscriber in the list.
- B. Endpoints attempt to register with the top subscriber in the list.
- C. If a subscriber is rebooted, endpoints deregister until the rebooted system is back in service.
- D. Endpoints attempt to register with both subscribers in a load-balanced method.
Answer: B
NEW QUESTION # 35
A company hosts a conference call with no local users.
How does the administrator stop the conference from continuing?
- A. removes the transcoder
- B. modifies the Drop Ad Hoc Conference service parameter
- C. modifies the Block OffNet to OffNet Transfer service parameter
- D. changes the codecs that are supported on the conference resource
Answer: B
Explanation:
Drop Ad Hoc Conference: This parameter determines how an ad hoc conference terminates. This is an important toll-fraud prevention setting, because inside facilitators can set up a conference call to expensive international numbers and then drop out of the call. Without the conference controller, international tariffs are billed back to the company in which the conference call was set up. Valid values are as follows:
- Never (default): The conference remains active after the conference controller and all on-net parties hang up. This default setting could result in potential toll fraud.
- When Conference Controller Leaves: Terminate the conference when the conference controller hangs up.
- When No On-Net Parties Remain in the Conference: Terminate the conference when there are no on-net parties remaining in the conference. This distinction is important because the conference controller might have to drop out of the call, but other business partners on the call should continue the conference. The When Conference Controller Leaves option would hang up the call when the conference controller left the conference.
NEW QUESTION # 36
Refer to the exhibit. An administrator is attempting to register a SIP phone to a Cisco UCM but the registration is failing. The IP address of the SIP Phone is 10.117.34 222 and the IP 1 address of the Cisco UCM is 10.0.101.10. Pings from the SIP phone to the Cisco UCM are successful.
What is the cause of this issue and how should it be resolved?
- A. DNS lookup for the Cisco UCM FQDN is failing. The SIP phone must be reconfigured with the proper DNS server.
- B. The certificates on the SIP phone are not trusted by the Cisco UCM. The SIP phone must generate new certificates.
- C. An network device is blocking TCP port 5060 from the SIP phone to the Cisco UCM. This device must be reconfigured to allow traffic from the IP phone.
- D. An NTP mismatch is preventing connection of the TCP session between the SIP phone and the Cisco UCM. The SIP phone and Cisco UCM must be set with identical NTP sources.
Answer: C
NEW QUESTION # 37
An engineer is configuring a Cisco Unified Border Element to allow the video endpoints to negotiate without the Cisco Unified Border Element interfering in the process. What should the engineer configure on the Cisco Unified Border Element to support this process?
- A. Configure a transcoder for video protocols.
- B. Configure path-thru content sdp on the voice service.
- C. Configure codec transparent on the dial peers.
- D. Configure a hardcoded codec on the dial peers.
Answer: C
NEW QUESTION # 38
Refer to the exhibit.
What causes the PRI issue?
- A. The framing is configured incorrectly
- B. The clock source is incorrect.
- C. The controller shut down
- D. The cable is unplugged
Answer: D
Explanation:
The show controller t1 command shows that the T1 interface is up but the line protocol is down. This indicates that the physical layer is working but the data link layer is not. The most likely cause of this is that the cable is unplugged.
NEW QUESTION # 39
Refer to the exhibit.
A collaboration engineer configures Cisco UCM to act as a DHCP server What must be done next to configure the DHCP server?
- A. Restart the TFTP service under Cisco Unified Serviceability
- B. Add the new DHCP server to the primary DNS server
- C. Restart the Cisco DHCP Monitor Service under Cisco Unified Serviceability.
- D. Add a DHCP subnet to the DHCP server under Cisco UCM Administration
Answer: B
NEW QUESTION # 40
......
Best 350-801 Exam Preparation Material with New Dumps Questions: https://www.pass4sures.top/CCNP-Collaboration/350-801-testking-braindumps.html
Updates For the Latest 350-801 Free Exam Study Guide!: https://drive.google.com/open?id=1vea6AvKyNuMd593Gl7_7y1NM2DDtQRQI