Free Aruba Certified Switching Associate (ACSA) V1 HPE6-A72 Ultimate Study Guide (Updated 90 Questions)
Get to the Top with HPE6-A72 Practice Exam Questions
NEW QUESTION 50
Refer to the exhibit.
What change on Core-1 will result in a successful ping to 10.1.1.254 from the management interface?
- A. Use the command ping 10.1.1.254 vrf mgmt
- B. Use the command ping 10.1.1.254/24
- C. The destination 10.1.1.254 requires configuring a static route
- D. Change the Core-1 management address to 10.1.1.1/25 first
Answer: A
NEW QUESTION 51
Refer to the exhibit.
All switches are running Aruba OS-CX. While working in the terminal of Access-2, you are unable to reach Server-1 using SSH.
What is the correct command to ping Server-1 from Access-2 to test reachability?
- A. Access-2# ping 172.16.1.97
- B. Access-2# ping6 172.16.1.97 vrf mgmt.
- C. Access-2# ping 172.16.1.97 vrf default
- D. Access-2# ping 172.16.1.97 vrf mgmt
Answer: D
NEW QUESTION 52
Which command can be used to find the serial number of an Aruba OS-CX switch?
- A. The command show system
- B. The command inventory
- C. The command show running-configuration
- D. The command version
Answer: A
Explanation:
Explanation/Reference:
NEW QUESTION 53
Which switch supports a maximum of 8 line-cards, 3 fabric modules, and 2 management cards?
- A. Aruba 6410
- B. Aruba 8400
- C. Aruba 5412r
- D. Aruba 8408
Answer: B
NEW QUESTION 54
You have completed a successful VSF stack between two switches.
Without manually assigning a backup switch, what is the expected output when issuing a show vsf command?
- A. Option A
- B. Option C
- C. Option B
- D. Option D
Answer: D
NEW QUESTION 55
What connectivity commands are available on AOS-CX switches? (Choose two.)
- A. pathping
- B. netstatus
- C. tracert
- D. traceroute
- E. ping
Answer: D,E
NEW QUESTION 56
Match each description to the correct term.
Answer:
Explanation:
NEW QUESTION 57
Refer to the exhibit.
Using the static IP address configured above, what is the converted binary value of the third octet assigned to the local interface?
- A. 0
- B. 1
- C. 2
- D. 01001011
Answer: C
NEW QUESTION 58
Refer to the exhibit
Which command on Access-2 port 1/1/4 will enable connectivity between PC-1 and Server-1 without any routing enabled in the network?
- A. Access-2 (config-if-1/1/4)# vlan access 20
- B. Access-2 (config-if-1/1/4)# vlan 20 untag 1/1/4
- C. Access-2 (config-if-1/1/4)# vlan access 1, 10, 20, 255
- D. Access-2 (config-if-1/1/4)# vlan trunk allow 1, 10, 255
Answer: A
NEW QUESTION 59
Match each network protocol to the correct default listening port and transport protocol. Not all answers will be used.
Answer:
Explanation:
NEW QUESTION 60
Refer to the exhibit.
What configuration is needed in order for "show LLDP configuration" to show this output?
- A. none; LLDP is enabled by default on Aruba switches
- B. configuring LLDP globally only
- C. configuring LLDP both globally and on the interfaces
- D. enabling LLDP on the interfaces only
Answer: A
NEW QUESTION 61
Which security benefit does SNMPv3 offer that SNMPv2 does not offer?
- A. Scopes
- B. RADIUS groups
- C. Data confidentially
- D. SSL encryption
Answer: C
NEW QUESTION 62
What are two OSPF attributes within the hello messages that must match to successfully establish neighbor relationships? (Choose two.)
- A. Hello and Dead intervals
- B. Router ID
- C. Priority
- D. Process ID
- E. Area ID
Answer: A,E
NEW QUESTION 63
What is Deep Packet Inspection?
- A. a function of Policy Based Routing that examines the entire IPv4 header to forward traffic based on factors other than destination address
- B. a firewall process of examining the packet header all the way to Layer 7 in order to determine if the packet should be permitted or denied
- C. a concept that applies to firewalls, when examining packets only up through Layer 4
- D. a machine learning method of packet inspection for the purpose of choosing which dynamic routing protocol to automatically assign
Answer: B
NEW QUESTION 64
Refer to the exhibit.
The above command was applied to an Aruba AOS-CX 6300M 24-port switch with 4-port SFP56 uplinks. All ports are set as access switchports.
Which ports carry VLAN 1 traffic?
- A. 1/1/1-1/1/24
- B. 1/1/8, 1/1/10, 1/1/5-1/1/24
- C. 1/1/1-1/1/28
- D. 1/1/8-1/1/10, 1/1/5-1/1/28
Answer: D
NEW QUESTION 65
......
Aruba Certified Switching Associate (HP HPE6-A72) Professional Exam Certification Path
Test Preparation teaches how the exam questions can to be decoded. Our Exam Preparedness: Aruba Certified Switching Associate (HP HPE6-A72)â Technical arrangement course is delivered in multiple configurations: study hall preparing for learning or taking an interest in a physical homeroom with an Approved Learner. Free media preparing for learning whenever it is suitable for you. The course surveys test inquiries in each branch of knowledge and how the themes tried ought to be seen to such an extent that off base answers are easier to stay away from. Our course will help you in tracking down the correct answers.
Learning Path:
- Learn Functions, features, and capabilities of Aruba single-site on-premise enterprise solutions
- Learn AP Provisioning
- Learn Control and monitor Aruba solutions
- Learn Guest Access
- Go through Aruba Networksâs resource library
- Learn Dynamic RF Management
- Learn WLAN basics and Aruba Architectures
- Learn Aruba WLAN safe employee and guest solutions
Pass HP HPE6-A72 exam - questions - convert Tets Engine to PDF: https://www.pass4sures.top/Aruba-Certified-Switching-Associate-ACSA-V1/HPE6-A72-testking-braindumps.html
Use Real HPE6-A72 Dumps Free Sample Questions and Practice Test Engine : https://drive.google.com/open?id=1mmNy4_0q0riqKydYOJr-WPvvSpofN8e7